Telescoping Mobile Surveillance 18M Endzone Camera System
product introduction:
Surveillance mast is designed for communications, reconnaissance, and surveillance applications.
This mast is lightweight and mobile, allows internal or external mountings for MRAP or shelter installations.
The masts are made up of multiple segments, each of which is spinning.
Attaching a few cables to the top of a tower and the other end to the ground, the mast can easily be pulled down.
specification:
hand winch up
| extended height (m) | No. Of section | Retracted height(m) | Outer tube range(mm) | Self weight (kg) | Max.payload (kg) |
| 3 | 2 | 1.6 | T50-T60 square | 3 | 50 |
| 4 | 3 | 1.4 | 50-60 -T70 | 4 | 40 |
| 5 | 3 | 1.77 | 50-60- T70 | 5 | 40 |
| 6 | 4 | 1.6 | 50-70 -T80 | 6.5 | 30 |
| 7 | 4 | 1.85 | 50-70- T80 | 7 | 30 |
| 8 | 5 | 1.7 | 40-70-T80 | 9 | 20 |
| 9 | 5 | 1.9 | 40-70- T80 | 10 | 20 |
| 10 | 6 | 1.75 | 40-80-T100 | 12 | 15 |
| 12 | 7 | 1.8 | 40-90-T100 | 28 | 10 |
| 15 | 8 | 1.95 | 40-100-T120 | | 10 |
Note: bottom square tube show as T-70, means: 70*70mm square tube
product photo:
features:
- 3 to 15m full extended models
- Car suitable transport length
- Hand push up
- Max 80mm Diameter Bottom Section -
- 25mm Diameter Top Section
- Aluminum 6063 tube 2mm thickness
- Stainless steel clamp fast fasten, without tool
- COMMERCIAL QUALITY
|
Application areas:
For WiFi, Portable Antennas, Elevated Photos
Ideal for:Emergency Response Antenna Systems, Restricted Space Antennas - Prepping Systems
Elevated Photography - Weather Instruments - WiFi Site Surveying - End Zone Cameras
Accessories:
Usually these masts require a flat or socket wrench, with the quick release clamps you can raise and lower the masts without any tools.
Even with limited space these quick clamps can be easily used, because the lever can be adjusted at any position. Just pull out and release the lever, the strong spring latches the lever at the desired position.
Attentions:
The mast can be extended to any length and securely locks into place by means of a massive clamp. The maximum allowed extended length is marked by a color ring approx. 20cm before the end of each tube. There is no fixed stop which makes it advisable to approach the marking slowly when extending the telescopes.
These masts are ideally suited for portable applications due to the low weight and the telescopic mechanism. When setting up the mast please pay special attention to the clamping length; the clamping length of the mast must be at least 1/6th of the extended length, or at least 1 meter at the minimum. When extending the mast more than 6 meters measured from the uppermost clamping point additional guys are mandatory.
The tubes are made of weather-proof aluminum alloy. The tubes are tapered by 5 mm and the tube thickness is 2mm. Please refer to the following table for weight and dimensions. The stated additional forces refer to a horizontally applied force at the tip of the extended mast - without guys and a mast clamping length of 1/6th. The calculation includes the inherent load at a wind speed of 50km/h (which is equivalent to a wind force of 7).
also we can produce according to clients special requests, and can give proposals.
Packing, delivery tiem, and shipping:
We will close then pack the goods safely in solid wooden box.
Prodcution lead time for sample: 2 weeks; 4 weeks for bulk order
Ship by sea, air, or express according to your request.
Product Tags:
|
|
Telescoping Mobile Surveillance 18M Endzone Camera System Images
|
